ZyXEL Communications ZyWall ATP series User Manual page 261

Each field is explained in the following table.
Table 105 Configuration > Network > Interface > VLAN > Add / Edit
LABEL DESCRIPTION
IPv4/IPv6 View / IPv4 Use this button to display both IPv4 and IPv6, IPv4-only, or IPv6-only configuration fields.
View / IPv6 View
Show Advanced Click this button to display a greater or lesser number of configuration fields.
Settings / Hide
Advanced Settings
Create New Object Click this button to create a DHCPv6 lease or DHCPv6 request object that you may use for
the DHCPv6 settings in this screen.
General Settings
Enable Interface Select this to turn this interface on. Clear this to disable this interface.
General IPv6 Setting
Enable IPv6 Select this to enable IPv6 on this interface. Otherwise, clear this to disable it.
Interface Properties
Interface Type Select one of the following option depending on the type of network to which the Zyxel
Device is connected or if you want to additionally manually configure some related
settings.
internal is for connecting to a local network. Other corresponding configuration options:
DHCP server and DHCP relay. The Zyxel Device automatically adds default SNAT settings for
traffic flowing from this interface to an external interface.
external is for connecting to an external network (like the Internet). The Zyxel Device
automatically adds this interface to the default WAN trunk.
For general, the rest of the screen's options do not automatically adjust and you must
manually configure a policy route to add routing and SNAT settings for the interface.
Interface Name This field is read-only if you are editing an existing VLAN interface. Enter the number of the
VLAN interface. You can use a number from 0~4094. For example, use vlan0, vlan8, and so
on. The total number of VLANs you can configure on the Zyxel Device depends on the
model.
Zone Select the zone to which the VLAN interface belongs.
Base Port Select the Ethernet interface on which the VLAN interface runs.
VLAN ID Enter the VLAN ID. This 12-bit number uniquely identifies each VLAN. Allowed values are 1 -
4094. (0 and 4095 are reserved.)
Priority Code This is a 3-bit field within a 802.1Q VLAN tag that's used to prioritize associated outgoing
VLAN traffic. "0" is the lowest priority level and "7" is the highest. See
The setting configured in Configuration > BWM overwrites the priority setting here.
Description Enter a description of this interface. It is not used elsewhere. You can use alphanumeric and
()+/:=?!*#@$_%-
IP Address
Assignment
Get Select this if this interface is a DHCP client. In this case, the DHCP server configures the IP
Automatically
address, subnet mask, and gateway automatically.
You should not select this if the interface is assigned to a VRRP group.
Chapter 9 Interfaces
characters, and it can be up to 60 characters long.
ZyWALL ATP Series User's Guide
261
Table 176 on page 433.