ZyXEL Communications ZyWall ATP series User Manual page 600

Table 246 Configuration > Object > AP Profile > Add/Edit Radio Profile (continued)
LABEL DESCRIPTION
General Settings
Activate Select this option to make this profile active.
Profile Name Enter up to 31 alphanumeric characters to be used as this profile's name. Spaces and
underscores are allowed.
Schedule This field displays the schedule object which defines when this radio profile can be used.
802.11 Band Select how to let wireless clients connect to the AP.
•
•
•
•
•
Channel Width Select the wireless channel bandwidth you want the AP to use.
A standard 20 MHz channel offers transfer speeds of up to 144Mbps (2.4GHz) or 217Mbps
(5GHZ) whereas a 40MHz channel uses two standard channels and offers speeds of up to
300Mbps (2.4GHz) or 450Mbps (5GHZ). An IEEE 802.11ac-specific 80MHz channel offers
speeds of up to 1.3Gbps.
40 MHz (channel bonding or dual channel) bonds two adjacent radio channels to increase
throughput. A 80 MHz channel consists of two adjacent 40 MHz channels. The wireless
clients must also support 40 MHz or 80 MHz. It is often better to use the 20 MHz setting in a
location where the environment hinders the wireless signal.
Because not all devices support 40 MHz and/or 80 MHz channels, select 20/40MHz or 20/
40/80MHz to allow the AP to adjust the channel bandwidth automatically.
Select 20MHz if you want to lessen radio interference with other wireless devices in your
neighborhood or the wireless clients do not support channel bonding.
Channel Select the wireless channel which this radio profile should use.
Selection
It is recommended that you choose the channel least in use by other APs in the region
where this profile will be implemented. This will reduce the amount of interference between
wireless clients and the AP to which this profile is assigned.
Select DCS to have the AP automatically select the radio channel upon which it
broadcasts by scanning the area around it and determining what channels are currently
being used by other devices.
Note: If you change the country code later, Channel Selection is set to Manual
Select Manual and specify the channels the AP uses.
Enable DCS This field is available when you set Channel Selection to DCS.
Client Aware
Select this to have the AP wait until all connected clients have disconnected before
switching channels.
If you disable this then the AP switches channels immediately regardless of any client
connections. In this instance, clients that are connected to the AP when it switches
channels are dropped.
Chapter 34 Object
11b/g: allows either IEEE 802.11b or IEEE 802.11g compliant WLAN devices to associate
with the AP. The AP adjusts the transmission rate automatically according to the
wireless standard supported by the wireless devices.
11b/g/n: allows IEEE802.11b, IEEE802.11g and IEEE802.11n compliant WLAN devices to
associate with the AP. The transmission rate of your AP might be reduced.
11a: allows only IEEE 802.11a compliant WLAN devices to associate with the AP.
11a/n: allows both IEEE802.11n and IEEE802.11a compliant WLAN devices to associate
with the AP. The transmission rate of your AP might be reduced.
11ac: allows only IEEE802.11ac compliant WLAN devices to associate with the AP.
automatically.
ZyWALL ATP Series User's Guide
600