Bridge Add/Edit - ZyXEL Communications ZyWall ATP series User Manual

Each field is described in the following table.
Table 109 Configuration > Network > Interface > Bridge
LABEL
Configuration / IPv6
Configuration
Add
Edit
Remove
Activate
Inactivate
Create Virtual
Interface
References
#
Status
Name
IP Address
Member
Apply
Reset

9.8.2 Bridge Add/Edit

This screen lets you configure IP address assignment, interface bandwidth parameters, DHCP settings,
and connectivity check for each bridge interface. To access this screen, click the Add or Edit icon in the
Bridge Summary screen. The following screen appears.
Chapter 9 Interfaces
DESCRIPTION
Use the Configuration section for IPv4 network settings. Use the IPv6 Configuration section
for IPv6 network settings if you connect your Zyxel Device to an IPv6 network. Both sections
have similar fields as described below.
Click this to create a new entry.
Double-click an entry or select it and click Edit to open a screen where you can modify the
entry's settings.
To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To open the screen where you can create a virtual interface, select an interface and click
Create Virtual Interface.
Select an entry and click References to open a screen that shows which settings use the
entry. See Section 9.3.4 on page 230
This field is a sequential value, and it is not associated with any interface.
This icon is lit when the entry is active and dimmed when the entry is inactive.
This field displays the name of the interface.
This field displays the current IP address of the interface. If the IP address is 0.0.0.0, the
interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address (STATIC) or dynamically
assigned (DHCP). IP addresses are always static in virtual interfaces.
This field displays the Ethernet interfaces and VLAN interfaces in the bridge interface. It is
blank for virtual interfaces.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
ZyWALL ATP Series User's Guide
272
for an example.