ZyXEL Communications ZyWall ATP series User Manual page 305

Figure 207 Configuration > Network > Routing > Policy Route > Add/Edit (IPv6 Configuration)
The following table describes the labels in this screen.
Table 121 Configuration > Network > Routing > Policy Route > Add/Edit
LABEL DESCRIPTION
Show Advanced Click this button to display a greater or lesser number of configuration fields.
Settings / Hide
Advanced Settings
Create new Object Use this to configure any new settings objects that you need to use in this screen.
Configuration
Enable Select this to activate the policy.
Description Enter a descriptive name of up to 31 printable ASCII characters for the policy.
Criteria
User Select a user name or user group from which the packets are sent.
Incoming Select where the packets are coming from; any, an interface, a tunnel, an SSL VPN, or the
Zyxel Device itself. For an interface, a tunnel, or an SSL VPN, you also need to select the
individual interface, VPN tunnel, or SSL VPN connection.
Source Address Select a source IP address object, including geographic address and FQDN (group)
objects, from which the packets are sent.
Destination Address Select a destination IP address object, including geographic address and FQDN (group)
objects, to which the traffic is being sent. If the next hop is a dynamic VPN tunnel and you
enable Auto Destination Address, the Zyxel Device uses the local network of the peer
router that initiated an incoming dynamic IPSec tunnel as the destination address of the
policy instead of your configuration here.
Chapter 10 Routing
ZyWALL ATP Series User's Guide
305