The Security Policy Control Add/Edit Screen - ZyXEL Communications ZyWall ATP series User Manual

25.4.2 The Security Policy Control Add/Edit Screen

In the Security Policy Control screen, click the Edit or Add icon to display the Security Policy Edit or Add
screen.
Figure 329 Configuration > Security Policy > Policy Control > Add
The following table describes the labels in this screen.
Table 191 Configuration > Security Policy > Policy Control > Add
LABEL
Create new
Object
Enable
Name
Description
From
To
Source
Destination
Service
Chapter 25 Security Policy
DESCRIPTION
Use to configure any new settings objects that you need to use in this screen.
Select this check box to activate the Security policy.
Type a name to identify the policy
Enter a descriptive name of up to 60 printable ASCII characters for the Policy. Spaces are
allowed.
For through-Zyxel Device policies, select the direction of travel of packets to which the policy
applies.
any means all interfaces.
Device means packets destined for the Zyxel Device itself.
Select an IPv4 / IPv6 address or address group object, including geographic address and FQDN
(group) objects, to apply the policy to traffic coming from it. Select any to apply the policy to all
traffic coming from IPv4 / IPv6 addresses.
Select an IPv4 / IPv6 address or address group, including geographic address and FQDN (group)
objects, to apply the policy to traffic going to it. Select any to apply the policy to all traffic going
to IPv4 / IPv6 addresses.
Select a service or service group from the drop-down list box.
ZyWALL ATP Series User's Guide
481