ZyXEL Communications ZyWall ATP series User Manual page 302

Figure 205 Configuration > Network > Routing > Policy Route
The following table describes the labels in this screen.
Table 120 Configuration > Network > Routing > Policy Route
LABEL DESCRIPTION
Show Filter / Hide Filter Click this button to display a greater or lesser number of configuration fields.
IPv4 Configuration / Use the IPv4 Configuration section for IPv4 network settings. Use the IPv6 Configuration
IPv6 Configuration section for IPv6 network settings if you connect your Zyxel Device to an IPv6 network. Both
sections have similar fields as described below.
Use IPv4/IPv6 Policy Select this to have the Zyxel Device forward packets that match a policy route according
Route to Override to the policy route instead of sending the packets directly to a connected network.
Direct Route
Add Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify
the entry's settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Move To change a rule's position in the numbered list, select the rule and click Move to display
a field to type a number for where you want to put that rule and press [ENTER] to move
the rule to the number that you typed.
The ordering of your rules is important as they are applied in order of their numbering.
Chapter 10 Routing
ZyWALL ATP Series User's Guide
302