Service Control Rules; Customizing The Www Login Page - ZyXEL Communications USG40 User Manual

Table 356 Configuration > System > WWW > Service Control (continued)
LABEL
Apply
Reset

43.7.5 Service Control Rules

Click Add or Edit in the Service Control table in a WWW, SSH, Telnet, FTP or SNMP screen to
add a service control rule.
Figure 584 Configuration > System > Service Control Rule > Edit
The following table describes the labels in this screen.
Table 357
LABEL
Create new
Object
Address Object
Zone
Action
OK
Cancel

43.7.6 Customizing the WWW Login Page

Click Configuration > System > WWW > Login Page to open the Login Page screen. Use this
screen to customize the Web Configurator login screen. You can also customize the page that
displays after an access user logs into the Web Configurator to access network services like the
Internet.
DESCRIPTION
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to return the screen to its last-saved settings.
Configuration > System > Service Control Rule > Edit
DESCRIPTION
Use this to configure any new settings objects that you need to use in this screen.
Select ALL to allow or deny any computer to communicate with the ZyWALL/USG using this
service.
Select a predefined address object to just allow or deny the computer with the IP address
that you specified to access the ZyWALL/USG using this service.
Select ALL to allow or prevent any ZyWALL/USG zones from being accessed using this
service.
Select a predefined ZyWALL/USG zone on which a incoming service is allowed or denied.
Select Accept to allow the user to access the ZyWALL/USG from the specified computers.
Select Deny to block the user's access to the ZyWALL/USG from the specified computers.
Click OK to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving
ZyWALL/USG Series User's Guide
Chapter 43 System
844