Mounting - ZyXEL Communications ZyWall ATP series User Manual

Figure 44 ATP200 Rear Panel
Figure 45 ATP500 Rear Panel
Figure 46 ATP800 Rear Panel
The following table describes the items on the rear panel.
Table 12 Rear Panel Items
LABEL
Console
Power
Lock
Fan
Note: Use an 8-wire Ethernet cable to run your Gigabit Ethernet connection at 1000 Mbps.
Using a 4-wire Ethernet cable limits your connection to 100 Mbps. Note that the
connection speed also depends on what the Ethernet device at the other end can
support.

3.2 Mounting

The Zyxel Device can be mounted in a rack.
Chapter 3 Hardware, Interfaces and Zones
DESCRIPTION
You can use the console port to manage the Zyxel Device using CLI commands. You will be
prompted to enter your user name and password. See the Command Reference Guide for
more information about the CLI.
When configuring using the console port, you need a computer equipped with
communications software configured to the following parameters:
• Speed 115200 bps
• Data Bits 8
• Parity None
• Stop Bit 1
• Flow Control Off
Use the included power cord to connect the power socket to a power outlet. Turn the power
switch on if your Zyxel Device has a power switch.
Attach a lock-and-cable from the Kensington lock (the small, metal-reinforced, oval hole) to a
permanent object, such as a pole, to secure the Zyxel Device in place.
The fans are for cooling the Zyxel Device. Make sure they are not obstructed to allow maximum
ventilation.
ZyWALL ATP Series User's Guide
66