The Routing Traces Screen - ZyXEL Communications ZyWall ATP series User Manual

Table 352 Maintenance > Diagnostics > Network Tool (continued)
LABEL
Mail Server Port
TLS Security
STARTTLS
Authenticate Server
Mail From
Mail To
SMTP Authentication
User Name
Password
Retype to Confirm
Test
Stop
Reset

40.8 The Routing Traces Screen

Click Maintenance > Diagnostics > Routing Traces to display this screen. Use this screen to configure a
traceroute to identify where packets are dropped for troubleshooting.
Figure 548 Maintenance > Diagnostics > Routing Traces
The following table describes the labels in this screen.
Table 353 Maintenance > Diagnostics > Routing Traces
LABEL
IP Address
Source
Port
Chapter 40 Diagnostics
DESCRIPTION
Enter the same port number here as is on the mail server for mail traffic.
Select this option if the mail server uses Transport Layer Security (TLS) for encrypted
communications between the mail server and the Zyxel Device.
Select this option if the mail server uses SSL or TLS for encrypted communications
between the mail server and the Zyxel Device.
Select this if the Zyxel Device authenticates the mail server in the TLS handshake.
Type the email address from which the outgoing email is delivered. This address is used in
replies.
Type the email address to which the outgoing email is delivered.
Select this check box if it is necessary to provide a user name and password to the SMTP
server.
This box is effective when you select the SMTP Authentication check box. Type the user
name to provide to the SMTP server when the log is emailed.
This box is effective when you select the SMTP Authentication check box. Type the
password to provide to the SMTP server when the log is emailed.
Retype your new password for confirmation.
Click this button to start the test.
Click this button to stop the test.
Click this button to return the screen to its last-saved settings.
DESCRIPTION
You can trace traffic through the Zyxel Device from a specific source-to-destination
stream or just from/to a specific host (source or destination).
Enter the source IP address of traffic that you want to trace.
Enter the source port number of traffic that you want to trace.
ZyWALL ATP Series User's Guide
790