Authentication Server - ZyXEL Communications ZyWall ATP series User Manual

Figure 503 Configuration > System > SNMP > Service Control Rule Add/Edit
The following table describes the labels in this screen.
Table 323 Configuration > System > SNMP > Service Control Rule Add/Edit
LABEL
Create new
Object
Address Object
Zone
Action
OK
Cancel

37.12 Authentication Server

You can set the Zyxel Device to work as a RADIUS server to exchange messages with a RADIUS client,
such as an AP for user authentication and authorization. Click Configuration > System > Auth. Server tab.
The screen appears as shown. Use this screen to enable the authentication server feature of the Zyxel
Device and specify the RADIUS client's IP address.
Chapter 37 System
DESCRIPTION
Use this to configure any new settings objects that you need to use in this screen.
Select ALL to allow or deny any computer to communicate with the Zyxel Device using SNMP.
Select a predefined address object to just allow or deny the computer with the IP address that
you specified to access the Zyxel Device using SNMP.
Select ALL to allow or prevent any Zyxel Device zones from being accessed using SNMP.
Select a predefined Zyxel Device zone on which a incoming service is allowed or denied.
Select Accept to allow the user to access the Zyxel Device from the specified computers.
Select Deny to block the user's access to the Zyxel Device from the specified computers.
Click OK to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving.
ZyWALL ATP Series User's Guide
738