ZyXEL Communications ZyWall ATP series User Manual page 247

Table 101 Configuration > Network > Interface > Cellular > Add / Edit (continued)
LABEL DESCRIPTION
Check Fail Enter the number of consecutive failures before the Zyxel Device stops routing through the
Tolerance
gateway.
Check Default Select this to use the default gateway for the connectivity check.
Gateway
Check this Select this to specify a domain name or IP address for the connectivity check. Enter that
address
domain name or IP address in the field next to it.
Check Port This field only displays when you set the Check Method to tcp. Specify the port number to
use for a TCP connectivity check.
Related Setting
Configure WAN Click WAN TRUNK to go to a screen where you can configure the interface as part of a
TRUNK
WAN trunk for load balancing.
Configure Policy Click Policy Route to go to the policy route summary screen where you can configure a
Route
policy route to override the default routing and SNAT behavior for the interface.
IP Address
Assignment
Get Select this option If your ISP did not assign you a fixed IP address. This is the default selection.
Automatically
Use Fixed IP Select this option If the ISP assigned a fixed IP address.
Address
IP Address Enter the cellular interface's WAN IP address in this field if you selected Use Fixed IP Address.
Assignment
Metric Enter the priority of the gateway (if any) on this interface. The Zyxel Device decides which
gateway to use based on this priority. The lower the number, the higher the priority. If two or
more gateways have the same priority, the Zyxel Device uses the one that was configured
first.
Device Settings
Band Selection This field appears if you selected a mobile broadband device that allows you to select the
type of network to use. Select the type of mobile broadband service for your mobile
broadband connection. If you are unsure what to select, check with your mobile
broadband service provider to find the mobile broadband service available to you in your
region.
Select auto to have the card connect to an available network. Choose this option if you do
not know what networks are available.
You may want to manually specify the type of network to use if you are charged differently
for different types of network or you only have one type of network available to you.
Select GPRS / EDGE (GSM) only to have this interface only use a 2.5G or 2.75G network
(respectively). If you only have a GSM network available to you, you may want to select this
so the Zyxel Device does not spend time looking for a WCDMA network.
Select UMTS / HSDPA (WCDMA) only to have this interface only use a 3G or 3.5G network
(respectively). You may want to do this if you want to make sure the interface does not use
the GSM network.
Select LTE only to have this interface only use a 4G LTE network. This option only appears
when a USG dongle for 4G technology is inserted.
Chapter 9 Interfaces
ZyWALL ATP Series User's Guide
247