How To Set Up Guest Wifi Network Accounts; Set Up The Wifi Guest Account, Address Range And Service Rule On The Zywall/Usg - ZyXEL Communications ZyWALL 110 Handbook

2.2 How to Set Up Guest WiFi Network Accounts

This is an example of using ZyWALL/USG to configure guest WiFi accounts to allow limited wireless
access to the Internet using only HTTP, HTTPS, and DNS protocols. For the wireless network setup,
please see the tutorial about How to Set Up WiFi with ZyXEL AP.
Figure 50 ZyWALL/USG with Guest WiFi Accounts Example
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks.
This example was tested using USG310 (Firmware Version: ZLD 4.13).
2.2.1 Set Up the WiFi Guest Account, Address Range and Service Rule on
the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Object > User/Group > User > Add A User to
1
configure the User Name the guest Wi-Fi user and set User Type to guest. Set a secured
Password (4-31 characters) and enter it again for confirmation.
Set the Authentication Timeout Settings to be Use Manual Settings to enter the number of
minutes this user has to renew the current session before the user is logged out.
Figure 51 CONFIGURATION > Object > User/Group > User > Add A User
Chapter 2 Set Up WiFi
ZyWALL/USG Series User's Guide
37