ZyXEL Communications ZyWall ATP series User Manual page 623

Table 259 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv4)
LABEL
Ending IP Address
Network
Netmask
Interface
Country
FQDN
OK
Cancel
34.6.2.2 IPv6 Address Add/Edit Screen
The Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv6) screen allows you to create a
new address or edit an existing one. To access this screen, go to the Address screen (see
on page 620), and click either the Add icon or an Edit icon in the IPv6 Address Configuration section.
Figure 404 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv6)
The following table describes the labels in this screen.
Table 260 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv6)
LABEL
Name
Object Type
IPv6 Address
IPv6 Starting
Address
IPv6 Ending
Address
Chapter 34 Object
DESCRIPTION
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the end
of the range of IP address that this address object represents.
This field is only available if the Address Type is SUBNET, in which case this field cannot be blank.
Enter the IP address of the network that this address object represents.
This field is only available if the Address Type is SUBNET, in which case this field cannot be blank.
Enter the subnet mask of the network that this address object represents. Use dotted decimal
format.
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the Address Type,
use this field to select the interface of the network that this address object represents.
If you selected Geography as the Address Type, use this field to select a country.
If you selected FQDN as the Address Type, use this field to enter a fully qualified domain name.
Click OK to save your changes back to the Zyxel Device.
Click Cancel to exit this screen without saving your changes.
DESCRIPTION
Type the name used to refer to the address. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is case-
_
sensitive.
Select the type of address you want to create.
Note: The Zyxel Device automatically updates address objects that are based on an
interface's IP address, subnet, or gateway if the interface's IP address settings
change. For example, if you change 1's IP address, the Zyxel Device
automatically updates the corresponding interface-based, LAN subnet
address object.
This field is only available if the Address Type is HOST. This field cannot be blank. Enter the IP
address that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the
beginning of the range of IP addresses that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the end
of the range of IP address that this address object represents.
ZyWALL ATP Series User's Guide
623
Section 34.6.2