Ap List: More Information - ZyXEL Communications ZyWall ATP series User Manual

Table 42 Monitor > Wireless > AP Information > AP List (continued)
LABEL
LED Status
Power Mode
The following table describes the icons in this screen.
Table 43 Monitor > Wireless > AP Information > AP List Icons
LABEL

6.15.1 AP List: More Information

Use this screen to look at station statistics for the connected AP. To access this screen, select an entry
and click the More Information button in the AP List screen. Use this screen to look at configuration
DESCRIPTION
This field displays the AP LED status.
N/A displays if the AP does not support LED suppression mode and/or have a locator
LED to show the actual location of the AP.
A gray LED icon signifies that the AP LED suppression mode is enabled. All the LEDs of
the AP will turn off after the AP is ready.
A green LED icon signifies that the AP LED suppression mode is disabled and the AP
LEDs stay lit after the AP is ready.
A sun icon signifies that the AP's locator LED is blinking.
A circle signifies that the AP's locator LED is extinguished.
This field displays the AP's power status.
Full - the AP receives power using a power adapter and/or through a PoE switch/
injector using IEEE 802.3at PoE plus. The PoE device that supports IEEE 802.3at PoE
Plus can supply power of up to 30W per Ethernet port.
Limited - the AP receives power through a PoE switch/injector using IEEE 802.3af PoE
even when it is also connected to a power source using a power adaptor. The PoE
device that supports IEEE 802.3af PoE can supply power of up to 15.4W per Ethernet
port.
When the AP is in limited power mode, the AP throughput decreases and has just
one transmitting radio chain.
It always shows Full if the AP does not support power detection.
DESCRIPTION
This AP is not on the management list.
This AP is on the management list and online.
This AP is in the process of having its firmware updated.
This AP is on the management list but offline.
This indicates one of the following cases:
• This AP has a runtime management VLAN ID setting that conflicts with the VLAN ID setting on the
Access Controller (the Zyxel Device).
• A setting the Zyxel Device assigns to this AP does not match the AP's capability.
ZyWALL ATP Series User's Guide
Chapter 6 Monitor
140