Body Control Module (Bcm) - Chrysler Stratus RHD 1999 Electronic Service Manual

JA
DIAGNOSIS AND TESTING (Continued)
CHEC 2 - WARNING LAMP DISPLAY
CHECK ENGINE
SEAT BELT
AIRBAG
CHARGING SYSTEM
LOW FUEL
HIGH BEAM INDICATOR
ENGINE TEMPERATURE
CRUISE
CHEC 3 - VACUUM FLORESCENT (VF)
DISPLAY
TRIP
ODOMETER CENTER
ODOMETER LOWER RIGHT
ODOMETER BOTTOM
ODOMETER LOWER LEFT
ODOMETER UPPER LEFT
ODOMETER TOP
ODOMETER UPPER RIGHT
ALL ODOMETER V/F DISPLAY DIGIT SEGMENTS
ON
CHEC 3
If any V/F segment does not light, replace Odome-
ter/Transmission Range Indication.
CHEC 4 - TRANSMISSION RANGE (VF)
DISPLAY - AUTOMATIC TRANSMISSION
PRND3L
PRND3L AND BOX AROUND P
PRND3L AND BOX AROUND R
PRND3L AND BOX AROUND N
PRND3L AND BOX AROUND D
PRND3L AND BOX AROUND 3
PRND3L AND BOX AROUND L
PRND3L AND ALL BOXES
END
INSTRUMENT PANEL AND SYSTEMS
CHEC 4 - AUTOMATIC TRANSMISSION
If any V/F segment does not light, replace Odome-
ter/Transmission Range Indication.
TRANSMISSION RANGE (VF) DISPLAY -
AUTOSTICK
PRND1234
PRND1234 AND BOX AROUND 1
PRND1234 AND BOX AROUND 2
PRND1234 AND BOX AROUND 3
PRND1234 AND BOX AROUND 4
PRND1234 AND BOX AROUND P
PRND1234 AND BOX AROUND R
PRND1234 AND BOX AROUND N
PRND1234 AND BOX AROUND D
PRND1234 AND ALL BOXES
END
CHEC 4 - AUTOMATIC TRANSMISSION
If any V/F segment does not light, replace Odome-
ter/Transmission Range Indication.
REMOVAL AND INSTALLATION

BODY CONTROL MODULE (BCM)

REMOVAL
The Junction Block and Body Control Module
(BCM) are attached to each other. After removal they
can be separated.
(1) Remove Junction Block / Body Control Module
from vehicle. Refer to Group 8O, Power Distribution
Systems for Removal and Installation.
(2) With the Junction Block/BCM removed from
the vehicle, separate the BCM from the Junction
Block.
(3) Remove the two BCM attaching screws and
release the two BCM locking latches from the Junc-
tion Block.
(4) Disconnect BCM from the Junction Block.
NOTE: The Remote Keyless Entry (RKE) module is
attached to the BCM with three screws. This must
be transferred (if equipped) to the new BCM if being
replaced.
NOTE: If BCM is replaced, the VTSS must be
enabled in the new BCM via the DRB lll in order to
start the vehicle.
8E - 3