Chrysler 1997 Stratus Convertible RHD Service Manual page 35

WHEEL SPEED CABLE BALL JOINT CAP SPEED SOR CABLE BRACKET ROUTING SENSOR SEN- STEERING KNUCKLE
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 10 Lower Control Arm Correctly Supported By
Jack Stand
(2) Remove wheel and tire assembly from location
on front of vehicle requiring upper control arm
removal.
(3) Remove the wheel speed sensor cable routing
bracket (Fig. 11) from the steering knuckle.
Fig. 11 Wheel Speed Sensor Cable Routing Bracket
(4) Remove the cotter pin and castle nut (Fig. 12)
from the upper ball joint stud.
(5) Remove the upper ball joint stud from the
steering knuckle using Puller, Special Tool, C-3894-A
(Fig. 13). Pull steering knuckle outward and position
toward the rear of the front wheel opening.
(6) Remove bolt (Fig. 14) attaching shock absorber
clevis to the shock absorber.
CAUTION: When removing the shock absorber cle-
vis to lower control arm thru-bolt (Fig. 15) do not
turn the thru-bolt in the clevis. The serrations on
the bolt and the clevis will be damaged.
BRAKE CALIPER LOWER CONTROL ARM FLEX HOSE ATTACHING BOLT ABSORBER SHOCK CLEVIS UPPER UPPER CLEVIS CASTLENUT UPPER CONTROL ARM SHOCK SHOCK ABSORBER STEERING
ing the shock absorber clevis to the lower control
arm.
BRACKET KNUCKLE MOUNTING BRACKET CONTROL ASSEMBLY CONTROL ABSORBER COTTER PIN ARM ARM
Fig. 12 Ball Joint Attachment To Steering Knuckle
Fig. 13 Ball Joint Stud Removal From Steering
Knuckle
Fig. 14 Shock Absorber Clevis Pinch Bolt
(7) Remove the nut and thru-bolt (Fig. 15) attach-
BALL JOINT BRAKE FLEX HOSE STEERING SHOCK ABSORBER KNUCKLE SPECIAL BALL JOINT STUD WHEEL BALL JOINT ABSORBER SHOCK PINCH BOLT AND NUT SENSOR CABLE ASSEMBLY C3894–A ASSEMBLY
SUSPENSION
TOOL SPEED
2 - 13