Show Voice Vlan - D-Link DXS-1210-12TC Reference Manual

49-6 voice vlan qos
This command is used to configure the CoS priority for the incoming voice VLAN traffic. Use the no
form of this command to revert to the default setting.
voice vlan qos COS-VALUE
no voice vlan qos
Parameters
COS-VALUE
Default
By default, this value is 5.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The voice packets arriving at the voice VLAN enabled port are marked to the CoS specified by the
command. The remarking of CoS allows the voice VLAN traffic to be distinguished from data traffic in
quality of service.
Example
This example shows how to configure the priority of the voice VLAN to be 7.
Switch# configure terminal
Switch(config)#voice vlan qos 7
Switch(config)#

49-7 show voice vlan

This command is used to display the voice VLAN configurations.
show voice vlan [interface [INTERFACE-ID [, | -]]]
show voice vlan {device | lldpmed device} [interface INTERFACE-ID [, | -]]
Parameters
interface
INTERFACE-ID
,
-
device
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the priority of the voice VLAN. This value must be between 0
and 7.
(Optional) Specifies to display voice VLAN information of ports.
(Optional) Specifies the interface to display.
(Optional)Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional)Specifies a range of interfaces. No space is allowed before
and after the hyphen.
(Optional) Specifies to display the voice devices learned by OUI.
371