D-Link DXS-1210-12TC Reference Manual page 108

13-2
This command is used to add or delete an entry of the DHCP server screen profile.
based-on hardware-address CLIENT-HARDWARE-ADDRESS
no based-on hardware-address CLIENT-HARDWARE-ADDRESS
Parameters
CLIENT-HARDWARE-
ADDRESS
Default
None.
Command Mode
Configure DHCP Server Screen Mode.
Command Default Level
Level: 12.
Usage Guideline
If a binding entry is defined with the client's MAC address, then the server message with the specified
server IP address and client address in the payload will be permitted. These binding entries restrict
that only specific servers are allowed to offer addresses to service specific clients.
If a binding entry is defined without the client's MAC address, then the server message with the
specified server IP address in the payload will be permitted. These binding entries restrict that only
specific servers are allowed to offer DHCP server services.
Example
This example shows how to configure a DHCP server screen profile named "campus-profile" which
contains a list of MAC addresses of clients.
Switch# configure terminal
Switch(config)#dhcp-server-screen profile campus-profile
switch(config-dhcp-server-screen)#based-on hardware-address 00-08-01-02-03-04
switch(config-dhcp-server-screen)# based-on hardware-address 00-08-01-03-00-01
switch(config-dhcp-server-screen)#
13-3
This command is used to clear the server screen log buffer.
clear ip dhcp snooping server-screen log
Parameters
None.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
DXS-1210 Series Smart Managed Switch CLI Reference Guide
based-on hardware-address
(Optional) Specifies the MAC address of the client.
clear ip dhcp snooping server-screen log
105