D-Link DXS-1210-12TC Reference Manual page 133

Switch#configure terminal
Switch(config)# erps instance 1
Switch(config-erp-instance)#profile campus
Switch(config-erp-instance)#
18-9
This command is used to specify the first ring port of a physical ring. Use the no form of this
command to remove the settings.
port0 interface INTERFACE-ID
Parameters
INTERFACE-ID
Default
None.
Command Mode
ERP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to specify or remove the first ring port of a physical ring.
Example
This example shows how to configure the interface "eth1/0/1" as the first ring port of the G.8032 ring
"ring1".
Switch#configure terminal
Switch(config)# erps instance 1
Switch(config-erps-instance)# port0 interface eth 1/0/1
Switch(config-erps-instance)#
18-10
This command is used to specify the second ring port of a physical ring. Use the no form of this
command to remove the settings.
port1 {interface INTERFACE_ID }
Parameters
INTERFACE_ID
Default
None.
Command Mode
DXS-1210 Series Smart Managed Switch CLI Reference Guide
port0
Specifies the interface ID of the first ring port. The interface(s) can be a
physical interface or a port-channel.
port1
Specifies the interface ID of the second ring port. The interface(s) can
be a physical interface or a port-channel.
130