D-Link DXS-1210-12TC Reference Manual page 240

Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# authentication timer reauthentication 200
Switch(config-if)#
30-5
This command is used to configure the timer to restart the authentication after the last failed
authentication. Use the no form of this command to revert to the default setting.
authentication timer restart SECONDS
no authentication timer restart
Parameters
SECONDS
Default
By default, this value is 60 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The Switch will be in the quiet state for a failed authentication session until the expiration of the timer.
Example
This example shows how to configurethe restart timer to 20 for eth1/0/1.
Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# authentication timer restart 20
Switch(config-if)#
30-6
This command is used to create a user in the local database for authentication. Use the no form of
this command to remove a user in the local database.
authentication username NAME password [0 | 7] PASSWORD [vlan VLAN-ID]
no authentication username NAME [vlan]
Parameters
NAME
0
7
DXS-1210 Series Smart Managed Switch CLI Reference Guide
authentication timer restart
Specifies the authentication restart timer value. The range is from 1 to
65535
authentication username
Specifies the username with a maximum of 32 characters.
(Optional) Specifies the password in the clear text form. If neither 0 nor
7 are specified, the default form is clear text.
(Optional) Specifies the password in the encrypted form. If neither 0
237