D-Link DXS-1210-12TC Reference Manual page 38

Example
This example shows how to enable the ACL hardware counter.
Switch# configure terminal
Switch(config)#acl-hardware-counter access-group abc
Switch(config)#
4-3 clear acl-hardware-counter
This command is used to clear the ACL hardware counter.
clear acl-hardware-counter access-group [ACCESS-LIST-NAME | ACCESS-LIST-NUMBER]
Parameters
access-group ACCESS-LIST-
NAME
access-group ACCESS-LIST-
NUMBER
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
If no access-list name or number is specified with the parameter access-group, all access-group
hardware counters will be cleared. If no access-map name is specified with the parameter vlan-filter,
all VLAN filter hardware counters will be cleared.
Example
This example shows how to clear the ACL hardware counter.
Switch(config)# clear acl-hardware-counter access-group abc
Switch#
4-4 expert access-group
This command is used to apply a specific expert ACL to an interface. Use the no form of this
command to cancel the application.
expert access-group {NAME | NUMBER} [in]
no expert access-group [NAME | NUMBER] [in]
Parameters
NAME
NUMBER
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the name of the accesslist to be cleared.
Specifies the number of the accesslist to be configured.
Specifies the name of the expert access-list to be configured. The
name can be up to 32 characters.
Specifies the number of the expert accesslist to be configured.
35