D-Link DXS-1210-12TC Reference Manual page 142

19-4
This command is used to enable MACaddress learning on the physical port. Use the no form of this
command to disable learning.
mac-address-table learning interface INTERFACE-ID [, | -]
no mac-address-table learning interface INTERFACE-ID [, | -]
Parameters
INTERFACE-ID
,
-
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this commands to enable or disable MACaddress learning on a physical port.
Example
This example shows how to enable the MAC address learning option.
Switch# configure terminal
Switch(config)#mac-address-table learning interface eth1/0/5
Switch(config)#
19-5
This command is used to add a static address to the MAC address table. Use the no form of this
command to remove a static MAC address entry from the table.
mac-address-table static MAC-ADDR vlan VLAN-ID {interface INTERFACE-ID [, | -] | drop}
no mac-address-table static {all | MAC-ADDR vlan VLAN-ID [interface INTERFACE-ID] [, | -]}
Parameters
MAC-ADDR
vlan VLAN-ID
interface INTERFACE-ID
DXS-1210 Series Smart Managed Switch CLI Reference Guide
mac-address-table learning
(Optional) Specifies the physical port interface to be configured.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and after
the hyphen.
mac-address-table static
Specifies the MAC address of the entry. The address can be a unicast
or a multicast entry. Packets with a destination address that match this
MAC address received by the specified VLAN are forwarded to the
specified interface.
Specifies the VLAN of the entry. The range is 1 to 4094.
Specifies the forwarding ports.
139