D-Link DXS-1210-12TC Reference Manual page 40

The name must be unique among all access lists. The characters used in the name are case
sensitive.If the accesslist number is not specified, the biggest unused number in the range of the
expert access list numbers will be assigned automatically.
Example
This example shows how to create an extended expert ACL.
Switch# configure terminal
Switch(config)# expert access-list extended exp_acl
Switch(config-exp-nacl)# end
Switch# show access-list
Access-List-Name
-------------------------------------- ---------------
exp_acl(ID: 8999)
Total Entries: 1
Switch#
4-6 ip access-group
This command is used to specify the IP accesslist to be applied to an interface. Use the no form of
this command to remove an IP access list.
ip access-group {NAME | NUMBER} [in]
no ip access-group [NAME | NUMBER] [in]
Parameters
NAME
NUMBER
in
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If an IP access group is already configured on the interface, the command applied later will overwrite
the previous setting. Only one access list of the same type can be applied to the same interface; but
access-lists of different types can be applied to the same interface.
The association of an access group with an interface will consume the filtering entry resource in the
switch controller. If the resources are insufficient to commit the command, then an error message will
be displayed. There is a limitation on the number of port operator resources. If applying the command
exhausts the available port selectors, then an error message will be displayed.
Example
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the name of the IP accesslist to be applied. The maximum
length is 32 characters.
Specifies the number of the IP accesslist to be applied.
(Optional) Specifies that the IP access list will be applied to check
packets in the ingress direction. If the direction is not specified, in is
used.
Type
expert ext-acl
37