D-Link DXS-1210-12TC Reference Manual page 242

Switch# clear authentication sessions interface eth 1/0/1
Switch#
30-8 authentication mac-move deny
This command is used to disable MAC move on the Switch. Use the no form of this command to
revert to the default setting.
authentication mac-move deny
no authentication mac-move deny
Parameters
None.
Default
By default, this option is permitted.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command control whether to allow authenticated hosts to do roaming across different switch
ports. This command only controls whether a host which is authenticated at a port set to multi-auth
mode is allowed to move to another port.
If a station is allowed to move, there are two situations. It may either need to be re-authenticated or
directly moved to the new port without re-authentication based on the following rule. If the new port
has the same authentication configuration as the original port, then re-authentication is not needed.
The host will inherit the same authorization attributes with new port. The authenticated host can do
roaming from port 1 to port 2, and inherit the authorization attributes without re-authentication. If the
new port has the different authentication configuration as the original port, then re-authentication is
needed. The authenticated host on port 1 can move and re-authenticated by port 2. If the new port
has no authentication method enabled, then the station is directly moved to the new port. The session
with the original port is removed. The authenticated host on port 1 can be moved to port 2.
If MAC move is disabled and an authenticated host moves to another port, then this is treated as a
violation error.
Example
This example shows how to enable MAC move on the Switch.
Switch# configure terminal
Switch(config)#authentication mac-move deny
Switch(config)#
30-9 authorization disable
This command is used to disable the acceptance of the authorized configuration. Use the no form to
enable the acceptance of the authorized configuration.
authorization disable
no authorization disable
DXS-1210 Series Smart Managed Switch CLI Reference Guide
239