D-Link DXS-1210-12TC Reference Manual page 176

Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port interface configuration.
Example
This example shows how to configure the port LACP timeout to long mode on Ethernet interface 1/0/1.
Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# lacp timeout long
Switch(config-if)#
24-4
This command is used to configure the system priority. Use the no form of this command to revert the
system priority back to the default value.
lacp system-priority PRIORITY
no lacp system-priority
Parameters
PRIORITY
Default
The default LACP system-priority is 32768.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
During LACP negotiation, the system priority and port priority of the local partner will be exchanged
with the remote partner. When the maximum number of actual members exceeds the limitation, the
Switch will use port priority to determine whether a port is operating in a backup mode or in an active
mode. The LACP system-priority determines the Switch that controls the port priority. Port priorities on
the other switch are ignored.
The lower value has a higher priority. If two switches have the same system priority, the LACP system
ID (MAC) determines the priority. The LACP system priority command applies to all LACP port-
channels on the Switch.
Example
This example shows how to configure the LACP system priority to be 30000.
Switch# configure terminal
Switch(config)#lacp system-priority 30000
Switch(config)#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
lacp system-priority
Specifies the system priority. The range is 1 to 65535.
173