D-Link DXS-1210-12TC Reference Manual page 98

Parameters
interface INTERFACE-ID
,
-
Default
None.
Command Mode
EXEC Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the test results for the cable diagnostics.
Example
This example shows how to display the test results for the cable diagnostics.
Switch# show cable-diagnostics
Port
------
-
eth1/0/1
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
eth1/0/6
eth1/0/7
eth1/0/8
Switch#
10-3
This command is used to clear the test results for the cable diagnostics.
clear cable-diagnostics {all | interface INTERFACE-ID [,|-]}
Parameters
DXS-1210 Series Smart Managed Switch CLI Reference Guide
(Optional) Specifies the interface's ID. The acceptable interface will be
a physical port.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
comma.
(Optional) Specifies a range of interfaces. No space before and after
the hyphen.
Type Link Status
---------- -------------
1000BASE-T Link Up
1000BASE-T Link Up
1000BASE-T Link Down
1000BASE-T Link Down
1000BASE-T Link Down
1000BASE-T Link Down
1000BASE-T Link Down
1000BASE-T Link Down
clear cable-diagnostics
Test Result
------------------------------
OK
OK
Shutdown
Shutdown
Unknown
Pair 1 Crosstalk at
Pair 2 Crosstalk at
Pair 3 OK
Pair 4 OK
NO Cable
Pair 1 Open
Pair 2 Open
Pair 3 OK
Pair 4 OK
95
Cable Length (M)
----------------
65
-
25
-
-
30M -
30M
at 110M
at 110M
-
at 16M -
at 16M
at 50M
at 50M