D-Link DXS-1210-12TC Reference Manual page 224

Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display MLD snooping information for all VLANs on which MLD snooping are
enabled by not specifying specific VLAN.
Example
This example shows how to display MLD snooping configurations.
Switch# show ipv6 mld snooping
MLD snooping global state: Enabled
VLAN #1 configuration
MLD snooping state
Fast leave
Querier state
Query version
Query interval
Max response time
Robustness value
Last listener query interval
Total Entries: 1
Switch#
28-13
This command is used to display MLD snooping group-related information learned on the Switch.
show ipv6 mld snooping groups [IPV6-ADDRESS | vlan VLAN-ID]
Parameters
IPV6-ADDRESS
vlan VLAN-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
: Enabled
: Enabled (host-based)
: Enabled (Non-active)
: v2
: 125 seconds
: 10 seconds
: 2
show ipv6 mld snooping groups
(Optional) Specifies the group IPv6 address. If no IPv6 address is
specified, all MLD group information will be displayed.
(Optional) Specifies the VLAN interface. If no interface is specified,
MLD group information about all interfaces will be displayed.
: 1 seconds
221