D-Link DXS-1210-12TC Reference Manual page 239

Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable periodic re-authentication for a port.
Example
This example shows how to enable periodic re-authentication on Ethernet port eth1/0/1.
Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# authentication periodic
Switch(config-if)#
30-4
This command is used to configure the timer to re-authenticate a session. Use the no form of this
command to revert to the default setting.
authentication timer reauthentication {SECONDS}
no authentication timer reauthentication
Parameters
SECONDS
Default
By default, this value is 3600 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the re-authentication timer.
Example
This example shows how to configure the re-authentication timer value to 200 for eth1/0/1.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
authentication timer reauthentication
Specifies the timer to re-authenticate a session. The range is from 1 to
65535.
236