D-Link DXS-1210-12TC Reference Manual page 334

on
off
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command can only assure that the flow control capability has been configured in the Switch
software and not guarantee the actual hardware operation. The actual hardware operation may be
different to the settings that have been configured on the Switch because the flow control capability is
determined by both the local port/device and the device connected at the other end of the link, not just
by the local device.
If the speed is set to the forced mode, the final flow control setting will be determined by the
configured flow control setting. If the speed is set to the auto mode, the final flow control setting will be
based on the negotiated result between the local side setting and the partner side setting. The
configured flow control setting here is the local side setting.
Example
This example shows how to enable the flow control on interface eth1/0/1.
Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# flowcontrol on
Switch(config-if)#
42-3
This command is used to configure the physical port interface's speed settings. Use the no form of
command to revert to the default setting.
speed { 100 | 1000 | 10giga | auto [SPEED-LIST]}
no speed
Parameters
100
1000
10giga
auto
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies to enable a port to send PAUSE frames or process PAUSE
frames from remote ports.
Specifies to disable the ability for a port to send or receive PAUSE
frames.
speed
Specifies to force the speed to 100 Mbps.
Specifies that for copper ports, it forces the speed to 1000 Mbps and
the user must manually set that the port operates as master or slave.
Specifies that for fiber ports (1000BASE-SX/LX), the port will disable
the auto-negotiation.
Specifies to force the speed to 10Gbps.
Specifies that for copper ports, it specifies to determine the speed and
flow control via auto-negotiation with its link partner.
Specifies that for fiber ports (1000BASE-SX/LX), it enables the auto-
negotiation option. Auto-negotiation will start to negotiate the clock and
flow control with its link partner.
331