D-Link DXS-1210-12TC Reference Manual page 152

Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. If the system can play the querier
role, the entity will listen for IGMP query packets sent by other devices. If IGMP query message is
received, the device with lower value of IP address becomes the querier.
Example
This example shows how to enable the IGMP snooping querier on VLAN 1.
Switch# configure terminal
Switch(config)#vlan 1
Switch(config-vlan)# ip igmp snooping querier
Switch(config-vlan)#
20-7
This command is used to configure the interval at which the IGMP snooping querier sends IGMP
general query messages periodically. Use the no form of this command to revert to the default setting.
ip igmp snooping query-interval SECONDS
no ip igmp snooping query-interval
Parameters
SECONDS
Default
By default, this value is 125 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. The query interval is the interval
between General Queries sent by the Querier. By varying the query interval, an administrator may
tune the number of IGMP messages on the network; larger values cause IGMP Queries to be sent
less often.
Example
This example shows how to configure the IGMP snooping query interval to 300 seconds on VLAN
1000.
Switch# configure terminal
Switch(config)#vlan 1000
Switch(config-vlan)# ip igmp snooping query-interval 300
Switch(config-vlan)#
20-8
This command is used to configure the maximum response time advertised in IGMP snooping queries.
Use the no form of this command to revert to the default setting.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
ip igmp snooping query-interval
Specifies to configure the interval at which the designated router sends
IGMP general-query messages. The range is 1 to 31744.
ip igmp snooping query-max-response-time
149