D-Link DXS-1210-12TC Reference Manual page 204

-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays LLDP traffic on each physical interface.
Example
This example shows how to display statistics information of port 1.
Switch#show lldp traffic interface ethernet 1/0/1
Port ID : eth1/0/1
---------------------------------------------
Total Transmits
Total Discards
Total Errors
Total Receives
Total TLV Discards
Total TLV Unknowns : 0
Total Ageouts
Switch#
Display Parameters
Total Transmits
Total Discards
Total Errors
Total Receives
Total TLV Discards
Total TLV Unknowns
Total Ageouts
25-26
This command is used to display LLDP snmp-server traps information.
show snmp-server traps lldp
DXS-1210 Series Smart Managed Switch CLI Reference Guide
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and after
the hyphen.
: 0
: 0
: 0
: 0
: 0
: 0
The total number of LLDP packets transmitted on the port.
The total number of LLDP frames discarded on the port for any reason.
The number of invalid LLDP frames received on the port.
The total number of LLDP packets received on the port.
The number of TLVs discarded.
The total number of LLDP TLVs received on the port where the type
value is in the reserved range, and not recognized.
The total number of times a complete remote data entry was deleted
for the port because the Time to Live interval expired.
show snmp-server traps lldp
201