D-Link DXS-1210-12TC Reference Manual page 190

25-14
This command is used to enable the LLDP advertise (transmit) capability. Use the no form of this
command to disable LLDP transmission.
lldp transmit
no lldp transmit
Parameters
None.
Default
By default, LLDP transmit is enabled on all supported interfaces.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port configuration. This command is used to enable LLDP
transmission on a physical interface. When LLDP is not running, the Switch doesn't transmit LLDP
messages.
Example
This example shows how to enable LLDP transmission.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp transmit
Switch(config-if)#
25-15
This command is used to configure the transmission delay timer. This delay timer defines the
minimum interval between the sending of LLDP messages due to constantly changing MIB content.
Use the no form of this command to revert to the default setting.
lldp tx-delay SECONDS
no lldp tx-delay
Parameters
SECONDS
Default
By default, this value is 2 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
DXS-1210 Series Smart Managed Switch CLI Reference Guide
lldp transmit
lldp tx-delay
Specifies the delay value for sending successive LLDPDUs on an
interface. The valid values are from 1 to 8192 seconds and should not
be greater than one-fourth of the transmission interval timer.
187