D-Link DXS-1210-12TC Reference Manual page 268

Parameters
dscp-cos DSCP-LIST to COS-
VALUE
DSCP-LIST
Default
CoS Value:
DSCP Value:
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The DSCP to CoS map is used by a DSCP trust port to map a DSCP value to an internal CoS value.
In turn this CoS value is then mapped to the CoS queue based on the CoS to queue map configured
by the priority-queue cos-map command.
Example
This example shows how to configure the DSCP to CoS map for mapping DSCP 12, 16, and 18 to
CoS 1 for eth2/0/6.
Switch# configure terminal
Switch(config)#interface eth 1/0/6
Switch(config-if)# mls qos map dscp-cos 12,16,18 to 1
Switch(config-if)#
34-3
This command is used to configure the scheduling mechanism. Use the no form of this command to
reset the packet scheduling mechanism to the default.
mls qos scheduler {sp | rr | wrr | wdrr}
no mls qos scheduler
Parameters
sp
rr
wrr
wdrr
Default
The default queue scheduling algorithm is WRR.
Command Mode
Interface Configuration Mode.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the list of DSCP code points to be mapped to a CoS value.
The range is from 0 to 63. The series of DSCPs can be separated by
commas (,) or hyphens (-) with no spaces or hyphens before and after.
Specifies the range of DSCP values.
0 1
0-7 8-15
mls qos scheduler
Specifies that all queues are in strict priority scheduling.
Specifies that all queues are in round-robin scheduling.
Specifies the queues in the frame count weighted round-robin
scheduling. If the weight of a queue be configured to zero, the queue
is in the SP scheduling mode.
Specifies the queues of all ports in the frame length (quantum)
weighted deficit round-robin scheduling. If the weight of a queue be
configured to zero, the queue is in the SP scheduling mode.
2 3 4
16-23 24-31 32-39
265
5 6 7
40-47 48-55 56-63