D-Link DXS-1210-12TC Reference Manual page 78

Use this command to enable AAA before the authentication and accounting via the AAA method lists
take effect. If AAA is disabled, the login user will be authenticated via the local user account table
created by the username command. The enable password will be authenticated via the local table
which is defined via the enable password command.
Example
This example shows how to enable the AAA function.
Switch#configure terminal
Switch(config)# aaa new-model
Switch(config)#
7-4 radius-server deadtime
This command is used to specify the default duration of the time to skip the unresponsive server. Use
the no form of this command to revert to the default setting.
radius-server deadtime MINUTES
no radius-server deadtime
Parameters
MINUTES
Default
By default, this value is 0.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command can be used to improve the authentication processing time by setting the dead time to
skip the unresponsive server host entries.
When the system performs authentication with the authentication server, it attempts one server at a
time. If the attempted server does not respond, the system will attempt the next server. When the
system finds a server does not respond, it will mark the server as down, start a dead time timer, and
skip them in authentication of the following requests until expiration of the dead time.
Example
This example shows how to set the dead time to ten minutes.
Switch#configure terminal
Switch(config)# radius-server deadtime 10
Switch(config)#
7-5 radius-server host
This command is used to create a RADIUS server host. Use the no form of this command to delete a
server host.
radius-server host {IP-ADDRESS | IPV6-ADDRESS} [auth-port PORT]
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the dead time. The valid range is 0 to 1440 (24 hours). When
the setting is 0, the unresponsive server will not be marked as dead.
75