Show Dot1X Statistics - D-Link DXS-1210-12TC Reference Manual

,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command can be used to display 802.1X diagnostics. Using this command without parameters
will display information about all interfaces. Otherwise, the diagnostics on the specified interface will
be displayed.
Example
This example shows how to display the dot1X diagnostics on Ethernet port 1/0/1.
Switch# show dot1x diagnostics interface ethernet 1/0/1
eth1/0/1 dot1x Diagnostics information are following:
pnacPortAuthEntersConnecting
pnacPortAuthEapLogoffsWhileConnecting
pnacPortAuthEntersAuthenticating
pnacPortAuthAuthSuccessWhileAuthenticating
pnacPortAuthAuthTimeoutsWhileAuthenticating
pnacPortAuthAuthFailWhileAuthenticating
pnacPortAuthAuthReauthsWhileAuthenticating
pnacPortAuthAuthEapStartsWhileAuthenticating
pnacPortAuthAuthEapLogoffWhileAuthenticating
pnacPortAuthAuthReauthsWhileAuthenticated
pnacPortAuthAuthEapStartsWhileAuthenticated
pnacPortAuthAuthEapLogoffWhileAuthenticated
pnacPortAuthBackendResponses
pnacPortAuthBackendAccessChallenges
pnacPortAuthBackendOtherRequestsToSupplicant
pnacPortAuthBackendNonNakResponsesFromSupplicant
pnacPortAuthBackendAuthSuccesses
pnacPortAuthBackendAuthFails
Switch#
3-14
This command is used to display IEEE 802.1X statistics. If no interface is specified, information about
all interfaces will be displayed.
show dot1x statistics [interface INTERFACE-ID [, | -]]
Parameters
DXS-1210 Series Smart Managed Switch CLI Reference Guide
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.

show dot1x statistics

: 2
: 0
: 2
: 0
: 0
: 0
: 0
: 1
: 0
: 0
: 0
: 0
: 2
: 0
: 0
: 2
: 0
: 0
29