D-Link DXS-1210-12TC Reference Manual page 89

Switch#show ip interface
Interface vlan1 is enabled, Link status is up
IP Address is 10.90.90.90/8 (Manual)
ARP timeout is 20 minutes.
Total Entries: 1
Switch#
8-8 ip enable
This command is used to set a primary or secondary IPv4 address for an interface, or acquire an IP
address on an interface from the DHCP. Use the no form of this command to remove the
configuration of an IP address or disable DHCP on the interface.
ip enable
no ip enable
Parameters
None
Default
Enable.
Command Mode
VLAN Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The IPv4 address of an interface can be either manually assigned by the user or dynamically
assigned by the DHCP server. For manual assignment, the user can assign multiple networks to a
VLAN, each with an IP address. Among these multiple IP addresses, one of them must be the primary
IP address and the rest are secondary IP address. The primary address will be used as the source IP
address for SNMP trap messages or SYSLOG messages that are sent out from the interface. Use the
no ip address command to delete the configured IP address entry.
Example
This example shows how to enable disable ip interface.
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# ip enable
Switch(config-if)#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
86