D-Link DXS-1210-12TC Reference Manual page 185

Dxs-1210 series l2 10 gigabit ethernet switch
Hide thumbs Also See for DXS-1210-12TC:
Table of Contents

Advertisement

configured addresses are removed. Multiple IPv4/IPv6 management addresses can be configured by
using this command multiple times.
Use the no lldp management-address command without a management address to disable the
management address adverted in LLDPDUs. If there is no effective management address in the list,
no Management Address TLV will be sent.
Example
This example shows how to enable eth1/0/1 and eth1/0/2 for setting the management address entry
(IPv4).
Switch# configure terminal
Switch(config)#interface range eth 1/0/1-1/0/2
Switch(config-if-range)# lldp management-address 10.1.1.1
Switch(config-if-range)#
This example shows how to enable eth3/0/3 and eth3/0/4 for setting the management address entry
(IPv6).
Switch# configure terminal
Switch(config)#interface range eth 1/0/3-1/0/4
Switch(config-if-range)# lldp management-address FE80::250:A2FF:FEBF:A056
Switch(config-if-range)#
This example shows how to delete the management address 10.1.1.1 from eth3/0/1 and eth3/0/2. If
10.1.1.1 is the last one, no Management Address TLV will be sent.
Switch# configure terminal
Switch(config)#interface range eth 1/0/1-1/0/2
Switch(config-if-range)# no lldp management-address 10.1.1.1
Switch(config-if-range)#
This example shows how to delete the management address FE80::250:A2FF:FEBF:A056 from
eth3/0/3. and eth3/0/4.
Switch# configure terminal
Switch(config)#interface range eth 1/0/3-1/0/4
Switch(config-if-range)# no lldp management-address FE80::250:A2FF:FEBF:A056
Switch(config-if-range)#
This example shows how to delete all management addresses from eth3/0/5 and then no
Management Address TLV will be sent on eth3/0/5.
Switch# configure terminal
Switch(config)#interface eth 1/0/5
Switch(config-if)# no lldp management-address
Switch(config-if)#
25-8
lldp med-tlv-select
This command is used to specify which optional LLDP-MED TLV will be transmitted and encapsulated
in the LLDPDUs and sent to neighbor devices. Use the no form of this commandto disable the
transmission of the TLVs.
lldp med-tlv-select [capabilities | inventory-management]
no lldp med-tlv-select [capabilities | inventory-management]
DXS-1210 Series Smart Managed Switch CLI Reference Guide
182

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dxs-1210-12scDxs-1210-10tsDxs-1210-16tc

Table of Contents