D-Link DXS-1210-12TC Reference Manual page 345

write-delay SECONDS
Default
By default, the severity level is warning (4).
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The system messages can be logged to the local message buffer or to other destinations. Messages
must enter the local message buffer first before it can be further dispatched to other destinations.
This command does not take effect if the specified discriminator does not exist. Thus the default
setting of the command is applied.
Specify the severity level of the messages in order to restrict the system messages that are logged in
the logging buffer (thus reducing the number of messages logged). The messages which are at the
specified severity level or higher will be logged to the message buffer. When the logging buffer is full,
the oldest log entries will be removed to create the space needed for the new messages that are
logged.
The content of the logging buffer will be saved to the FLASH memory periodically such that the
message can be restored on reboot. The interval for periodically writing the logging buffer to FLASH
can be specified. The content of the logged messages in the FLASH will be reloaded into the logging
buffer on reboot.
Example
This example shows how to enable the logging of messages to the logging buffer and restrict logging
of messages with a security level of errors or higher.
Switch# configure terminal
Switch(config)#logging buffered severity errors
Switch(config)#
44-3
This command is used to create a SYSLOG server host to log the system messages or debug output.
Use the no form of this command to remove a SYSLOG server host.
logging server {IP-ADDRESS | IPV6-ADDRESS} [severity {SEVERITY-LEVEL | SEVERITY-
NAME}] [facility FACILITY-TYPE] [port UDP-PORT]
no logging server {IP-ADDRESS | IPV6-ADDRESS}
Parameters
IP-ADDRESS
IPV6-ADDRESS
SEVERITY-LEVEL
SEVERITY-NAME
DXS-1210 Series Smart Managed Switch CLI Reference Guide
(Optional) Specifies to disable periodical writing of the logging buffer to
the FLASH.
logging server
Specifies the IP address of the SYSLOG server host.
Specifies the IPv6 address of the log server host.
(Optional) Specifies the severity level of system messages. The
messages at that severity level or a more severe level will be logged to
the log server. This value must be between 0 and 7. 0 is the most
severe level. If not specified, the default severity level is warnings (4).
(Optional)Specifies the severity level of system messages by one of
the following names: emergencies, alerts, critical, errors, warnings,
notifications, informational, debugging.
342