D-Link DXS-1210-12TC Reference Manual page 33

interface INTERFACE-ID
,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command can be used to display 802.1X statistics. Using this command without parameters will
display information about all interfaces.Otherwise, the statistics on the specified interface will be
displayed.
Example
This example shows how to display dot1X statistics on Ethernet port 1/0/1.
Switch# show dot1x statistics interface eth 1/0/1
eth1/0/1 dot1x statistics information:
EAPOL Frames RX
EAPOL Frames TX
EAPOL-Start Frames RX
EAPOL-Req/Id Frames TX
EAPOL-Logoff Frames RX
EAPOL-Req Frames TX
EAPOL-Resp/Id Frames RX
EAPOL-Resp Frames RX
Invalid EAPOL Frames RX
EAP-Length Error Frames RX
Last EAPOL Frame Version
Last EAPOL Frame Source
Switch#
3-15
This command is used to display IEEE 802.1X session statistics. If no interface specified, information
about all interfaces will be displayed.
show dot1x session-statistics [interface INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
DXS-1210 Series Smart Managed Switch CLI Reference Guide
(Optional) Specifies to display the dot1x diagnostics on the specified
interface or range of interfaces. If not specified, information about all
interfaces will be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
show dot1x session-statistics
(Optional) Specifies to display the dot1x diagnostics on the specified
interface or range of interfaces. If not specified, information about all
: 1
: 4
: 0
: 6
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 00-10-28-00-19-78
30