Basic Ipv6 Commands - D-Link DXS-1210-12TC Reference Manual

9. Basic IPv6 Commands

9-1 clear ipv6 neighbors
This command is used to clear IPv6 neighbor cache dynamic entries.
clear ipv6 neighbors {all | INTERFACE-ID}
Parameters
all
INTERFACE-ID
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command will only clear dynamic neighbor cache entries.
Example
This example shows how to clear IPv6 neighbor cache entries associated with interface VLAN 1:
Switch# enable
Switch# clear ipv6 neighbors vlan1
Switch#
9-2 ipv6 address
This command is used to manually configure an IPv6 addresses on the interface. Use the no form of
this command to delete a manually configured IPv6 address.
ipv6 address {IPV6-ADDRESS/PREFIX-LENGTH | IPV6-ADDRESS link-local}
no ipv6 address {IPV6-ADDRESS/PREFIX-LENGTH | IPV6-ADDRESS link-local}
Parameters
IPV6-ADDRESS
PREFIX-LENGTH
link-local
Default
None.
Command Mode
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies to clear the dynamic neighbor cache entries associated with
all interfaces.
Specifies to clear dynamic neighbor cache entries associated with the
specified interface will be cleared.
Specifies the IPv6 address and the length of prefix for the subnet.
Specifies the length of the prefix. The prefix of the IPv6 address is
also a local subnet on the interface.
Specifies a link-local address to be configured.
87