Commands - D-Link DXS-1210-12TC Reference Manual

3. 802.1X Commands
3-1 clear dot1x counters
This command is used to clear 802.1X counters (diagnostics, statistics and session statistics).
clear dot1x counters {all | interface INTERFACE-ID [, | -]}
Parameters
all
interface INTERFACE-ID
,
-
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to clear 802.1X counters (diagnostics, statistics and session statistics).
Example
This example shows how to clear 802.1X counters (diagnostics, statistics and session statistics) on
the Ethernet port 1/0/1.
Switch# clear dot1x counters interface eth 1/0/1
Switch#
3-2 dot1x control-direction
This command is used to configure the direction of the traffic on a controlled port bidirectional (both).
Use the no form of this command to revert to the default setting.
dot1x control-direction {both}
no dot1x control-direction
Parameters
both
Default
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies to clear 802.1X counters (diagnostics, statistics and session
statistics) on all interfaces.
Specifies to clear 802.1X counters (diagnostics, statistics and session
statistics) on the specified interface. Valid interfaces are physical ports
(including type, stack member, and port number).
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
Specifies to enable bidirectional control for the port.
20