D-Link DXS-1210-12TC Reference Manual page 312

Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display Spanning Tree interface level configuration. The command can be used
for all STP versions.
Example
This example shows how to display spanning tree configuration information for interface eth1/0/1.
Switch#show spanning-tree configuration interface ethernet 1/0/1
eth1/0/1
Spanning tree state : Enabled
Port path cost: 0
Port priority: 128
Port Identifier:
Link type: auto
Port fast: auto
Guard root: Disabled
TCN filter : Disabled
Bpdu forward: Disabled
Hello Time
Switch#
39-4
This command is used to enable the spanning tree to send SNMP notifications for STP. Use the no
form of this command to disable the sending of notifications for STP.
snmp-server enable traps stp [new-root] [topology-chg]
no snmp-server enable traps stp [new-root] [topology-chg]
Parameters
new-root
topology-chg
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
DXS-1210 Series Smart Managed Switch CLI Reference Guide
128.1
: 2
snmp-server enable traps stp
(Optional) Specifies the sending of STP new root notification.
(Optional) Specifies the sending of STP topology change notification.
309