Table of Contents
Advertisement
SPEED-LIST
Default
The speed will be set as auto for 1000BASE-T interfaces.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If the specified speed is not supported by the hardware, error messages will be returned.
If speed is set to 1000 Mbps, or 10 Gbps, then the duplex mode cannot be set to half-duplex. If the
duplex mode is set to half-duplex, then the speed cannot be set to 1000 Mbps, or 10 Gbps.
Auto-negotiation will be enabled if either the speed parameter is set to auto, or the duplex parameter
is set to auto. If the speed parameter is set to auto, and the duplex parameter is set to the fixed mode.
Only the speed will be negotiated. The advertised capability will be configured to the duplex mode
combined with all the possible speeds. If the speed is to set to a fixed speed and duplex is set to auto,
only the duplex mode is negotiated. The advertised capability will be both full and half-duplex mode
combined with the configured speeds.
For 10GBASE-R connections, if auto-negotiation is enabled, the system will automatically configure
the speed (1000M or 10G) according to the type of SFP/SFP+.
Example
This example shows how to configure eth1/0/1 to only auto-negotiate to 10 or 100 Mbps.
Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# speed auto 100,1000
Switch(config-if)#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
(Optional) Specifies a list of speeds that the Switch will only auto-
negotiate to. The speed can be 100,1000, and/or 10giga. Use a
comma(,) to separate multiple speeds. If the speed list is not specified,
all speed will be advertised.
332
Hide quick links:
Advertisement
Table of Contents
