D-Link DXS-1210-12TC Reference Manual page 328

Parameters
MINUTES
Default
By default, this aging time is 720 minutes.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the aging time for aging out the surveillance device and the
surveillance VLAN automatically learned member ports.
When the last surveillance device connected to the port stops sending traffic, and the MAC address of
this surveillance device is aged out, the surveillance VLAN aging timer will be started. The port will be
removed from the surveillance VLAN after expiration of surveillance VLAN aging timer.
If the surveillance traffic resumes during the aging time, the aging timer will be cancelled.
Example
This example shows how to configure the aging time of surveillance VLAN to 30 minutes.
Switch# configure terminal
Switch(config)#surveillance vlan aging 30
Switch(config)#
41-3
This command is used to enable the surveillance VLAN state of ports. Use the no form of this
command to disable the surveillance VLAN state of ports.
surveillance vlan enable
no surveillance vlan enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is available for physical port and port-channel interface configuration.
The command takes effect for access ports or hybrid ports.
Use this command to enable the surveillance VLAN function for ports.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the aging time of surveillance VLAN. The range is from 1 to
65535 minutes.
surveillance vlan enable
325