Basic Ipv4 Commands - D-Link DXS-1210-12TC Reference Manual

8. Basic IPv4 Commands

8-1 arp
This command is used to add a static entry in the Address Resolution Protocol (ARP) cache. Use the
no form of this command to remove a static entry in the ARP cache.
arp IP-ADDRESS HARDWARE-ADDRESS
no arp IP-ADDRESS HARDWARE-ADDRESS
Parameters
IP-ADDRESS
HARDWARE-ADDRESS
Default
No static entries are installed in the ARP cache.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The ARP table keeps the network layer IP address to local data-link MAC address association. The
association is kept so that the addresses will not have to be repeatedly resolved. Use this command
to add static ARP entries.
Example
This example shows how to add a static ARP entry for a typical Ethernet host.
Switch# configure terminal
Switch(config)# arp 10.31.7.19 0800.0900.1834
Switch(config)#
8-2 arp timeout
This command is used to set the ARP aging time for the ARP table. Use the no form of this command
to revert to the default setting.
arp timeout MINUTES
no arp timeout
Parameters
MINUTES
Default
The default value is 20 minutes.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the network layer IP address.
Specifies the local data-link Media Access (MAC) address (a 48-bit
address).
Specifies the dynamic entry that will be aged-out if it has no traffic
activity within the timeout period. The valid values are from 0 to 65535.
81