D-Link DXS-1210-12TC Reference Manual page 132

Parameters
MEL-VALUE
Default
By default, the value is 1.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure ring MEL value of an ERP instance. The configured MEL value of
all ring nodes participate in the same ERP instance should be identical.
Example
This example shows how toconfigure the ring MEL value of ERP instance 1 as 6.
Switch#configure terminal
Switch(config)# erps instance 1
Switch(config-erp-instance)#level 6
Switch(config-erp-instance)#
18-8
This command is used to associate an ERP instance with a G.8032 profile.Use the no form of this
command to remove the association
profile PROFILE-NAME
Parameters
PROFILE-NAME
Default
None.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to associate an ERP instance with a G.8032 profile. Multiple ERP instances
can be associated with the same G.8032 profile. The instances associated with the same profile
protect the same set of VLANs, or the VLANs protected by one instance is a subset of LANs
protected by another instance.
Example
This example shows how to associate the profile "campus" with instance 1.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the ring MEL of the specified ERP instance. The valid values
are from 0 to 7.
profile
Specifies the profile name to be associated with the ERP instance.
129