D-Link DXS-1210-12TC Reference Manual page 141

Default
By default, this value is 300 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Setting the aging time to 0 will disable the MAC address table aging out function.
Example
This example shows how to set the aging time value to 200 seconds.
Switch# configure terminal
Switch(config)#mac-address-table aging-time 200
Switch(config)#
19-3 mac-address-table aging destination-hit
This command is used to enable the destination MAC address triggered update function. Use the no
form of this command to disable the destination MAC address triggered updated function.
mac-address-table aging destination-hit
no mac-address-table aging destination-hit
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The source MAC address triggered update function is always enabled. The hit bit of MAC address
entries corresponding to the port that receives the packet will be updated based on the source MAC
address and the VLAN of the packet. When the user enables the destination MAC address triggered
update function by using the mac-address-table aging destination-hit command, the hit bit of MAC
address entries corresponding to the port that transmit the packet will be updated based on the
destination MAC address and the VLAN of the packet.
The destination MAC address triggered update function increases the MAC address entries hit bit
update frequency and reduce traffic flooding by the MAC address entries aging time-out.
Example
This example shows how to enable the destination MAC address triggered update function.
Switch# configure terminal
Switch(config)#mac-address-table aging destination-hit
Switch(config)#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
138