D-Link DXS-1210-12TC Reference Manual page 337

Privilege EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to clear the system's configuration, including stacking information. The
configuration data will revert to the default settings and then save it to the start-up configuration file
and then reboot switch. Before using this command, save a backup of the configuration using the
copy command or upload the configuration profile to the TFTP server.
Example
This example shows how to reset the system to the factory default settings.
Switch# reset system
This command will clear all of system configuration as factory
default setting including IP parameters and stacking information.
Clear system configuration, save, reboot? (y/n) [n]
Saving configurations and logs to NV-RAM...... Done.
Please wait, the switch is rebooting...
43-3
This command is used to copy a file to another file.
copy imageid IMAGE-ID tftp://LOCATION/DESTINATION-URL
copy log tftp://LOCATION/DESTINATION-URL
copy running-config {startup-config| tftp://LOCATION/DESTINATION-URL | config1| config2}
copy startup-config tftp://LOCATION/DESTINATION-URL
copy tftp://LOCATION/SOURCE-URL
copy tftp://LOCATION/SOURCE-URL startup-config
Parameters
LOCATION
imageid
IMAGE-ID
tftp://LOCATION/DESTINATION-
URL
log
running-config
startup-config
config1
config2
Default
DXS-1210 Series Smart Managed Switch CLI Reference Guide
copy
(Optional) Specifies the IPv4 address or IPv6 address of the TFTP
server.
The imageid used for the backup
Specifies iamge ID 1 or 2
A file name with tftp server path
tftp://location/filename
Command "copy tftp://LOCATION/SOURCE-URL" is used to upgrade
image.
Backup current log file
Backup current system running confirgration
Backup boot-up configuration
Save to config1
Save to config2
334
y