D-Link DXS-1210-12TC Reference Manual page 236

Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# spanning-tree mst hello-time 1
Switch(config-if)#
29-9
This command is used to configure the bridge priority value for the selected MSTP instance. Use the
no form of this command to revert to the default setting.
spanning-tree mst INSTANCE-ID priority PRIORITY
no spanning-tree mst INSTANCE-ID priority
Parameters
INSTANCE-ID
PRIORITY
Default
By default, this value is 32768.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The priority has same meaning with as the bridge priority in the STP command reference, but can
specify a different priority for distinct MSTP instances.
Example
This example shows how to configure the bridge priority for the MSTP instance 2.
Switch# configure terminal
Switch(config)#spanning-tree mst 2 priority 0
Switch(config)#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
spanning-tree mst priority
Specifies the MSTP instance identifier. Instance 0 represents the
default instance, CIST.
Specifies the bridge priority value that must be divisible by 4096. The
range is from 0 to 61440.
233