D-Link DXS-1210-12TC Reference Manual page 138

18-14
This command is used to activate the specified ERP instance.Use the no form of this command to
deactivate the specified ERP instance.
activate
no activate
Parameters
None.
Default
By default, this option is no activate.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to activate or deactivate the specified ERP instance. The ring ports, APS
channel, and ERP profile must be configured before activating the ERP instance.
The activated ERP instance will be in non-operational state, if the specified APS channel does not
exist, or the specified ports are not the tagged member port of the APS channel VLAN.
Example
This example shows how to activate the instance 1.
Switch#configure terminal
Switch(config)# erps instance 1
Switch(config-erp-instance)#activate
Switch(config-erp-instance)#
18-15
This command is used to configure timers for an ERP domain.Use the no form of this command to
revert to the default settings.
timer {guard MILLI-SECONDS | hold-off SECONDS | wtr MINUTES}
no timer {guard | hold-off | wtr}
Parameters
guard MILLI-SECONDS
hold-off SECONDS
wtr MINUTES
DXS-1210 Series Smart Managed Switch CLI Reference Guide
activate
timer
(Optional) Specifies the guard timer in milliseconds. The value is range
from 10 to 2000.
(Optional) Specifies the hold-off timer in seconds. The value is range
from 0 to 10.
(Optional) Specifies the WTR timer in minutes. The value is range from
1 to 12.
135